VS03

	ONE-MORE TECHNOLOGY CO., LTD Tel : +886-2-22225253 ; 02-22225253 Fax: +886-2-22226055 No.310, Yuanshan Rd., Zhonghe Dist., New Taipei 235, Taiwan Email : contact us	Sprinkler Irrigation VS03

One-More Technology CO., LTD is the leading Taiwan manufacturer, supplier and exporter of Garden Water Timer which are formulated to suit individuals' personal needs. Our range is available in high quantities and at most competitive pricing. We are also capable to offer our entire range as per the requirements of our customers. Our produce is available at very reasonable prices.. More models of our products wanted, please contact us now!


Model: VS03 (S1203) Garden Water Timer Watering Timer Set the watering duration Program your timer before connecting to the tap. Rotate the Duration Dial to the desired watering duration. The Duration dial has 12 settings: * OFF – the valve will close and remain closed when the dial is in this setting. * ON – the valve will open and remain open when the dial is in this setting. * 1, 2, 3, 5, 10, 15, 30, 60, 90, 120 min - the water will come on automatically at the intervals shown by the frequency dial and remain on for the chosen duration . To change the watering duration while the valve is open simply rotates the dial to the new duration. The valve will close first and open again for the duration shown on the duration dial regardless of how long the valve had been open prior to the change. More details please contact us, thank you!
Instructions VS Series ◎Installation 1. The timer must be a fixed installation. 2. The faucet connection should be towards the top. Screw connection up by hand. Do not over tighten or use a wrench to avoid nut breaking. 3. Please cover and fasten the transparent cover. Otherwise can not waterproof and cause failure. ◎Battery installation 1. Open the transparent cover. 2. Pull the battery compartment out of the timer. 3. For VS01 , please install two full 1.2V~1.5V Ni-MH rechargeable batteries. (The batteries must be fully 2.4V at least for the first time use; otherwise, timer will not work.); For VS03, please use two alkaline batteries which voltage is higher than 2.4V. 4. Place the battery compartment back in the timer, after you insert the batteries. Then close the cover fully. ‧When the battery voltage is below a safe operating voltage, the indicator will appear red light and the valve will be closed. ◎Set the watering interval Turn the frequency dial to the desired watering frequency. The frequency dial has 12 settings: ‧ Minute - 5，10，15，30 mins ‧ Hour - 1，2，4，8，12 hr ‧ Day - 1，2，3 day. ◎Set the watering duration ‧ Program your timer before connecting to the tap. Rotate the Duration Dial to the desired watering duration. The Duration dial has 12 settings: ‧ OFF – the valve will close. ‧ ON – the valve will open. ‧ 15, 30 sec 1, 3, 5, 10, 15, 20, 30, 60 min - the water will come on automatically at the intervals shown by the frequency dial and remain on for the chosen duration . ‧ To change the watering duration while the valve is open simply rotates the dial to the new duration. The valve will close first and open again for the duration shown on the duration dial regardless of how long the valve had been open prior to the change. Note: * When the batteries installation is done, the valve will be turned off automatically right away. The water will not come on until after the first complete interval. For example, if the timer is programmed at 1 pm, and the interval dial is set to come on every four hours. At 5 pm, the valve will open. If immediate watering is needed, then a manual watering interval may be started. * Timer will not work when the duration is the same or longer than the frequency. For example, the timer will think this is meaningless setting if you set up timer to work 30 mins every 10 mins. ◎Rain stop function (For VS01) The rain sensor is the 2 contacts on top, next to the solar panel. Timer will stop immediately when raining, and it will not work until next running time after sensor is dry.

上次修改日期： 2024年04月25日。